![]() ![]() ![]() ![]() Please reset target", just turn off and on ariva. I also had to turn off and on the stb after it sync'd, to start the flashing process. That happened to me once before, as far as i can remember, but i just flashed an earlier original firmware version and upgraded it then. i know the description of what is happening is long winded but i imagine it might also be of help to others who are trying to sort the " ASH "problem out on their respective boxes.so any ideas what i am doing wrong ?.thanks in advance. I am going around in circles and getting dizzy but achieving nothing so any advice would be appreciated I read on another post to switch the box off and on again to start the flash process but i end up back at the message If i hit the cancel button at the bottom of the screen it saysÄownloading.are you sure you want to cancelÄ«ut still nothing happens, nothing downloads, even if i left it there till christmas. The box stays on this setting with nothing happening When i click back and then next without changing any of the settings and leaving the box on i get a message Set my port : to COM 1, BIT RATE : 115200, PARITY : EVEN, OPERATE MODE : UPGRADE and i ticked INCLUDE BOOTLOADER.I then browsed for the ferguson firmware file V1.26B3 abs file which was approx 8mb in size and then hit next ( bye the way my stb was switched off at this stage while entering the information into the erom tool ) after hitting next i turned on the box and got a message " synchronising STBs Done went through the procedure as explained here in another post. I have bricked or should i say a fellow that was trying to install a patch on it bricked it but thats a touchy subject as i have to try and fix it, anyway i have a 250 Ariva and downloaded the latest firmware from the Ferguson website V1.26B3 and the EROM UPGRADE TOOL 2.0.1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |